Nissan Murano: Brake Control System :: Vdc/tcs/abs / Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake Control System :: Vdc/tcs/abs / Removal and Installation

Normal Operating Condition

Description Symptom Result Brake pedal slightly vibrates and operation sound (motor sound and sound from suspension) occurs when VDC function, TCS function, ABS function, EBD function, brake assist function, hill start assist function operates...

Wheel Sensor

..

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2135 Tp Sensor


DTC Description DTC DETECTION LOGICRationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2135 TP SENSOR-B1 (Throttle/Pedal position sensor/switch “A” / “B” voltage correlation) Diagnosis condition Start engine and let it idle Signal (terminal) TP sensor 1 signal and TP sensor 2 signal Threshold Rationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2 Diagnosis delay time — POSSIBLE CAUSE Harness or connector (TP sensor 1 or 2 circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: B2416 Touch Sen R Open


DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2416–1B TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – B2416–1E TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – POSSIBLE CAUSE Improper installation of touch sensor Touch sensor RH Harness or connectors (touch sensor circuit is open) Automatic back door control module FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Categories

Luggage hooks

Nissan Murano. Luggage hooks

When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

read more

 
Copyright © 2026 www.nimurano.com