Nissan Murano: Removal and Installation / Vdc Off Switch
Exploded View

| 1. |
Upper switch carrier |
2. |
Middle switch carrier |
3. |
Heated steering wheel switch (if equipped) |
| 4. |
VDC OFF switch |
5. |
Automatic back door switch (if equipped) |
6. |
Mask |
| 7. |
Mask |
8. |
Lower switch carrier |
9. |
Front power return switch (if equipped) |
| 10. |
Instrument lower panel LH |
11. |
Illumination control switch |
|
|
Removal and Installation
REMOVAL
Remove instrument lower panel LH. Refer to Removal and Installation.
Remove screws and middle switch carrier from instrument lower panel LH.
Release pawls using suitable tool and remove VDC OFF switch from the middle switch carrier.

INSTALLATION
Installation is in the reverse order of removal.
Exploded View
1.
ABS actuator and electric unit (control unit)
2.
Bracket
A.
To rear (RH) brake caliper. Refer to Exploded View.
B.
From master cylinder secondary side...
Removal and Installation
The yaw rate/side/decel G sensor is an integral part of the ABS actuator and electric unit (control unit) and cannot be disassembled...
Other information:
DTC Description
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
Check Intelligent Key relative signal strength.
Confirm Nissan Murano vehicle Intelligent Key antenna signal strength...
The sunshade is made from a tricot material.
CAUTION
To help prevent damaging the moonroof
while cleaning:
Do not rub the material with a cloth.
Doing so can damage the surface of
the material or cause a stain to
spread.
Never use benzine, thinner or any
similar chemical to clean the sunshade...