Nissan Murano: Storage / Overhead sunglasses storage

To open the sunglasses holder, push and
release.
Only store one pair of sunglasses in the
holder.
WARNING
Keep the sunglasses holder closed
while driving to avoid obstructing the
driver’s view and to help prevent an
accident.
CAUTION
Do not use for anything other than
sunglasses.
Do not leave sunglasses in the sunglasses
holder while parking in direct
sunlight. The heat may damage the
sunglasses.
Front console
Bench seat
WARNING
Do not recline the rear seatback when
you use the cup holders on the rear
armrest. Doing so may cause the beverages
to spill over, and if they are hot,
they may scald the passengers...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
B2422–78
BACK DOOR STATE
(Back door state)
Diagnosis condition
All times
Signal (terminal)
Encoder LH A signal, encoder LH B signal, encoder RH A signal, encoder RH B signal (automatic back door control module connector terminal: 19, 20, 21)
Threshold
When the automatic back door control module detect the encoder pulse signal LH does not according with the encoder pulse signal RH
Diagnosis delay time
–
B2422–79
BACK DOOR STATE
(Back door state)
Diagnosis condition
All times
Signal (terminal)
–
Threshold
When automatic back door position information is deleted from automatic back door control module memory
Diagnosis delay time
–
POSSIBLE CAUSE
Improper installation of back door assembly
Calibration of automatic back door position information
Back door mechanism
Encoder
Harness or connectors (encoder circuit is open or shorted)
Automatic back door control module
Battery terminal is disconnected and reconnected
FAIL-SAFEInhibit automatic back door system auto open/close function
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Brake lines and cables: Visually inspect for
proper installation. Check for chafing,
cracks, deterioration, and signs of leaking.
Replace any deteriorated or damaged
parts immediately.
Brake pads and rotors: Check for wear,
deterioration and fluid leaks...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more