Nissan Murano: How to use the remote keyless entry function / Opening windows

Nissan Murano (Z52) 2015-2024 Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® / How to use the remote keyless entry function / Opening windows

The Intelligent Key allows you to simultaneously open windows equipped with automatic operation.

To open the windows, press and hold the Nissan Murano. Opening windows button on the Intelligent Key for longer than 3 seconds.

The door windows will lower while holding down the Nissan Murano. Opening windows button on the Intelligent Key.

NOTE:

The windows will stop lowering at the time the Nissan Murano. Opening windows button is released. However, the Intelligent Key cannot be used from inside the vehicle to lower the windows. The door windows cannot be closed with the Intelligent Key.

    Unlocking doors

    Press the button on the Intelligent Key. The driver’s door will unlock and the hazard warning lights flash once, and the front and tail lights may turn on for 30 seconds...

    Releasing the rear liftgate (if so equipped)

    The rear liftgate can be opened and closed by performing the following: Press the button for longer than 1 second to open the rear liftgate. Press the button again for longer than 1 second to close the rear liftgate...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Symptom Diagnosis. Cvt Control System


    Symptom Table The diagnosis item number indicates the order of check. Start checking in the order from 1. Perform diagnoses of symptom table 1 before symptom table 2. Symptom Table 1 Symptom Engine system CAN communication line Transmission range switch (P0705, P0706) Input speed sensor (P0715, P0716, P0717) Primary speed sensor (P0791, P0792, P0793) Secondary speed sensor (P2765, P2766, P2767) CVT fluid temperature sensor (P0711, P0712, P0713) Primary pressure sensor (P084C, P084D) Secondary pressure sensor (P0841, P0847, P0848) Torque converter clutch solenoid valve (P0740, P0743, P0744) Manual mode switch Stall test CVT position Power supply Control valve CVT fluid level and state Ignition switch and starter Work Flow DTC Index Work Procedure Inspection and Adjustment Diagnosis Procedure Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive) Inspection Wiring Diagram, Wiring Diagram - IGNITION POWER SUPPLY - Shift Shock Large shock (N→ D position) 1 4 8 3 6 2 9 5 Large shock (N→ R position) 1 4 8 3 6 2 9 5 Shock is too large for lock-up...

    Nissan Murano (Z52) 2015-2024 Service Manual: Linking Key Fob to the Meter Display


    Description Always perform when the battery terminal is disconnected or the driver seat control unit is replaced. Linking key fob to the meter display will not operate normally if no memory storage is performed. Work Procedure Intelligent Key Interlock Storage ProcedurePerforming the following operation associates the registered driving position with Intelligent Key...

    Categories

    Driver and passenger supplemental knee air bag

    Nissan Murano. Driver and passenger supplemental knee air bag

    Driver’s side

    The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.

    Nissan Murano. Driver and passenger supplemental knee air bag

    Passenger’s side

    read more

     
    Copyright © 2026 www.nimurano.com