Nissan Murano: Inspection and Adjustment / Linking Key Fob to the Meter Display
Always perform when the battery terminal is disconnected or the driver seat control unit is replaced. Linking key fob to the meter display will not operate normally if no memory storage is performed.
Intelligent Key Interlock Storage Procedure
Performing the following operation associates the registered driving position with Intelligent Key. When driver door unlock operation is performed by Intelligent Key or driver door request switch, display of the registered driving position and turnout operation can be performed.
STEP 1
Check the following conditions:
-
Ignition switch: ON
-
Initialization: done
-
Driving position: registered
>>
GO TO 2.
STEP 2
-
Switch ignition from ON to OFF (ADP memory automatically at the ignition OFF timing).
>>
GO TO 3.
STEP 3
Confirm the operation of each part with memory operation and linking a key fob to the meter display operation.
>>
Inspection End.
Memory Storing
Description
Always perform the memory storage when the battery terminal is disconnected or the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed...
System Setting
Description
The settings of the automatic drive positioner system can be changed using CONSULT, the display unit in the center of the instrument panel and the set switch...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis System (audio Unit)
Description The audio unit on board diagnosis performs the following functions listed in the table below: Mode Description Self Diagnosis Audio system diagnosis. Diagnoses the connections across system components. Confirmation/Adjustment Display Diagnosis The following check functions are available: Color Spectrum Bar Gradation Bar Touch Panel White Display Screenshot to USB y-curve Nissan Murano Vehicle Signals Diagnosis of signals can be performed for Vehicle Speed, Ignition, Illumination Control, MR out, Illumination Switch, Reverse, Parking Brake and ACC...
Nissan Murano (Z52) 2015-2024 Service Manual: U0428 Steering Angle Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0428 ST ANGLE SENSOR CALIBRATION (Steering angle sensor calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSE Neutral position adjustment of steering angle sensor is not complete Steering angle sensor FAIL-SAFE Predicted course line is not displayed MOD (Moving Object Detection) function is stopped DTC Confirmation Procedure CHECK DTC PRIORITY If DTC U0428 is displayed with DTC U1232, first perform the diagnosis for DTC U1232...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- Checking engine oil level
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
