Nissan Murano: Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Removal and Installation

The Ambient Temperature Display Is Incorrect

Diagnosis Procedure The displayed outside air temperature is higher than the actual temperature. The displayed outside air temperature is lower than the actual temperature...

Combination Meter

Exploded View 1. Combination meter 2. Cluster lid A Metal clip Removal and Installation REMOVALCAUTION: Never install a combination meter from an Advanced Driver Assistance System (ADAS) equipped Murano Nissan Murano vehicle into a non-ADAS equipped vehicle, or vice versa...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Seat Back Heater Sensor

Component Function Check CHECK SEAT BACK HEATER FUNCTION Check whether or not the temperature of the seat back heater changes in accordance with the HEAT switch operation of the climate controlled seat control switch. Is the inspection result normal? YES>> Inspection End...

Nissan Murano (Z52) 2015-2024 Service Manual: Driver Air Bag Module

Exploded View 1. Steering wheel 2. Cover 3. Steering switches 4. Driver air bag module A. Driver air bag module bolt Pawl Removal and Installation WARNING: Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.