Nissan Murano: Lan System :: Can Gateway / Precaution. Precautions

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Lan System :: Can Gateway / Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation:

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

  • Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

  • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation:

  • When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

  • When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

    Lan System :: Can Gateway

    ..

    System Description

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: U0104-82 Adas Can 1


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0104-82 ADAS CAN CIR1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Side radar detected an error of ITS communication signal that was received from ADAS control unit Diagnosis delay time – POSSIBLE CAUSE ADAS control unit Side radar RH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...

    Nissan Murano (Z52) 2015-2024 Service Manual: B2720 Corner Sensor [rl]


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2720–60 CORNER SENSOR [RL] (Rear sonar sensor LH outer) — Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (reset error) Diagnosis delay time — B2720–61 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (configuration error) Diagnosis delay time — B2720–62 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (power supply error) Diagnosis delay time — B2720–63 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (self diag result) Diagnosis delay time — B2720–65 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (over temperature) Diagnosis delay time — B2720–66 Diagnosis condition When ignition switch is ON Signal (terminal) Rear sonar sensor LH outer signal (terminal 22) Threshold Rear sonar sensor LH outer signal circuit is open or short to ground Diagnosis delay time — B2720–67 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (diag dump error) Diagnosis delay time — B2720–68 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (resonator error) Diagnosis delay time — B2720–83 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (CRC error) Diagnosis delay time — B2720–92 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Rear sonar sensor LH outer internal failure (membrane error) Diagnosis delay time — POSSIBLE CAUSE Harness or connectors Rear sonar sensor LH outer FAIL-SAFE Obstacle detection of rear sonar sensor LH outer is stopped Audible warning (sonar buzzer) of all sensors is stopped Sonar buzzer sounds for 3 seconds DTC Confirmation Procedure DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com