Nissan Murano: Blind Spot Warning (BSW) (if so equipped) / How to enable/disable the BSW system
Perform the following steps to enable or
disable the BSW system.
Using “Settings” in the vehicle information
display:
- Press the button until
“Settings”
displays in the vehicle information display
and then press the OK button. Use
the button to select “Driver
Assistance.”
Then press the OK button.
- Select “Blind Spot” and press the OK
button.
Using the “Driving Aids” screen in the vehicle
information display:
- Use the buttons on the
steering
wheel to scroll to the Driving Aids
screen.
- Press the OK button to access the
Driver Assistance menu.
- Select “Blind Spot” and press OK to
change the Driving Aids setting.
NOTE:
- When enabling/disabling the system,
the system will retain current settings
even if the engine is restarted.
- The RCTA system (if so equipped) is
integrated into the BSW system.
There is not a separate selection in
the vehicle information display for
the RCTA system. When the BSW is
disabled, the RCTA system is also disabled.
- When the BSW system is turned on,
the BSW/RCTA indicator (white) in the
vehicle information display illuminates.
Side BSW/RCTA Indicator Light
BSW/RCTA Indicator
The BSW system operates above approximately
20 mph (32 km/h).
If the radar sensors detect a vehicle in the
detection zone, the side BSW/RCTA indicator
light (1) illuminates...
WARNING
Listed below are the system limitations
for the BSW system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death...
Other information:
CAUTION
Be careful not to allow children to swallow
the battery or removed parts.
NISSAN INTELLIGENT KEY®
Replace the battery in the Intelligent Key as
follows:
Remove the mechanical key from the
Intelligent Key.
Insert a small flathead screwdriver
into the slit of the corner
and twist it
to separate the upper part from the
lower part...
The sensor is located on the
front of the
vehicle.
To keep the system operating properly, be
sure to observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas
around the sensor.
Do not cover or attach stickers or similar
objects on the front bumper near
the sensor area...