Nissan Murano: Transmission & Driveline / Front Axle :: Removal and Installation

Front Drive Shaft

Inspection Check drive shaft mounting point and joint for looseness and other damage. Check boot for cracks and other damage. CAUTION: Replace entire drive shaft when noise or vibration occurs from drive shaft...

Front Wheel Hub

Exploded View 1. Cotter pin 2. Nut retainer 3. Disc brake rotor 4. Wheel hub and bearing 5. Wheel stud 6. Splash guard 7. Steering knuckle Front Removal and Installation REMOVALRemove disc brake rotor...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U1320 Reprogramming

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition U1320–06 REPROGRAMMING (Automatic back door reprogramming) Diagnosis condition All times Signal (terminal) – Threshold When the automatic back door control module configuration is not successful Diagnosis delay time – U1320–42 REPROGRAMMING (Automatic back door reprogramming) Diagnosis condition All times Signal (terminal) – Threshold When the automatic back door control module configuration is not successful Diagnosis delay time – U1320–51 REPROGRAMMING (Automatic back door reprogramming) Diagnosis condition All times Signal (terminal) – Threshold When the automatic back door control module configuration is not successful Diagnosis delay time – POSSIBLE CAUSE Improper installation of back door assembly [CALIBRATION OF AUTOMATIC BACK DOOR POSITION INFORMATION]: not complete Back door mechanism Automatic back door control module Harness or connectors FAIL-SAFE— DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Av Control Unit

Diagnosis Procedure CHECK FUSE Check that the following fuses are not blown: Terminal No. Signal name Fuse No. Capacity 7 ACC power supply 7 10 A 17 Ignition power supply 29 10 A 19 Battery power supply 15 20 A Are the fuses blown? YES>> Replace the blown fuse after repairing the affected circuit...