Nissan Murano: Remote Engine Start (if so equipped) / Conditions the Remote Engine Start will notwork
The Remote Engine Start will not operate if
any of the following conditions are present:
- The ignition switch is placed in the ON
position.
- The hood is not securely closed.
- The hazard indicator lights are on.
- The engine is still running. The engine
must be completely stopped. Wait at
least 6 seconds if the engine goes from
running to off. This is not applicable
when extending engine run time.
- The
button is not pressed
and
held for at least 2 seconds.
- The
button is not pressed
and
held within 5 seconds of pressing the
lock button.
- The brake is pressed.
- The doors are not closed and locked.
- The liftgate is open.
- The I–Key Indicator Light remains solid
is in the vehicle information display.
- The alarm sounds due to illegal entry
into the vehicle.
- Two Remote Engine Starts, or a single
Remote Engine Start with an extension,
have already been used.
- The vehicle is not in P (Park).
- There is a detected registered key already
inside of the vehicle.
- The Remote Engine Start function has
been switched to the OFF position in
Vehicle Settings of the vehicle information
display. For additional information,
refer to “Vehicle information display” in
the “Instruments and controls” section
of this manual.
The Remote Engine Start may display a
warning or indicator in the vehicle information
display. For additional information, refer
to “Vehicle information display” in the
“Instruments and controls” section of this
manual.
To cancel a Remote Engine Start, perform
one of the following:
Aim the Intelligent Key at the vehicle
and press until the parking
lights
turn off...
Pull the hood lock release handle
located below the driver side instrument
panel until the hood springs up
slightly.
Locate the lever in between
the
hood and grille and push the lever sideways
with your fingertips and raise the
hood ...
Other information:
This transmission has a high fluid temperature
protection mode. If the fluid temperature
becomes too high (for example,
when climbing steep grades in high temperatures
with heavy loads, such as when
towing a trailer), engine power and, under
some conditions, vehicle speed will be decreased
automatically to reduce the
chance of transmission damage...
* It is recommended that you visit a NISSAN dealer for replacement.
Always check with the Parts Department at a NISSAN dealer for the latest
parts information.
Map light
Headlight assembly
Personal light
Door mirror turn signal light
Fog light (if so equipped)
High-mounted stop light
License plate light
Backup (reversing) light assembly
Rear combination light
Cargo light
Daytime running light
Replacement procedures
All other lights are either type A, B, C or D...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more