Nissan Murano: Remote Engine Start (if so equipped) / Canceling a Remote Engine Start

Nissan Murano (Z52) 2015-2024 Owners Manual / Pre-driving checks and adjustments / Remote Engine Start (if so equipped) / Canceling a Remote Engine Start

To cancel a Remote Engine Start, perform one of the following:

  • Aim the Intelligent Key at the vehicle and press Nissan Murano. Canceling a Remote Engine Start until the parking lights turn off.
  • Turn on the hazard warning flashers.
  • Cycle the ignition switch on and then off.
  • The extended engine run time has expired.
  • The first 10 minute timer has expired.
  • Opening the engine hood.
  • Shifting the vehicle out of P (Park).
  • The alarm sounds due to illegal entry into the vehicle.
  • Pushing the ignition switch without the Intelligent Key in the vehicle.
  • Not pressing the brake pedal while pressing the ignition switch with the Intelligent Key in the vehicle.

    Extending engine run time

    The Remote Engine Start feature can be extended one time by performing the steps listed in “Remote starting the vehicle” in this section. Run time will be calculated as follows: The first 10 minute run time will start when the Remote Engine Start function is performed...

    Conditions the Remote Engine Start will notwork

    The Remote Engine Start will not operate if any of the following conditions are present: The ignition switch is placed in the ON position. The hood is not securely closed...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Automatic Speed Control Device (ascd)


    System Description SYSTEM DIAGRAMBASIC ASCD SYSTEMRefer to Owner's Manual for ASCD operating instructions.Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predetermined constant speed without depressing accelerator pedal. Driver can set Nissan Murano vehicle speed in advance between approximately 40 km/h (25 MPH) and 144 km/h (89 MPH)...

    Nissan Murano (Z52) 2015-2024 Service Manual: P0137 Ho2s2


    DTC Description DTC DETECTION LOGICThe heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com