Nissan Murano: Remote Engine Start (if so equipped) / Extending engine run time
The Remote Engine Start feature can be extended one time by performing the steps listed in “Remote starting the vehicle” in this section. Run time will be calculated as follows:
- The first 10 minute run time will start when the Remote Engine Start function is performed.
- The second 10 minutes will start immediately when the Remote Engine Start function is performed again. For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
- Extending engine run time will bring you to the two Remote Engine Start limit.
A maximum of two Remote Engine Starts, or a single Remote Engine Start with an extension, are allowed between ignition cycles. The ignition switch must be cycled to the ON position and then back to the OFF position before the Remote Engine Start procedure can be used again.
Remote starting the vehicle
To use the Remote Engine Start feature
perform the following:
Aim the Intelligent Key at the vehicle.
Press the button to lock
all
doors.
Within 5 seconds press and hold
the button until the turn signal
lights flash and the tail lamps turn on...
Canceling a Remote Engine Start
To cancel a Remote Engine Start, perform
one of the following:
Aim the Intelligent Key at the vehicle
and press until the parking
lights
turn off...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0196 Eot Sensor
DTC Description DTC DETECTION LOGIC Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signals from EOT sensor and intake air temperature sensor. The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the signal voltage of the EOT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...
Nissan Murano (Z52) 2015-2024 Service Manual: Remote Keyless Entry Function
System Description SYSTEM DIAGRAMSYSTEM DESCRIPTIONThe Intelligent Key has the same functions as the remote control entry system. Therefore, it can be used in the same manner as the remote controller by operating the door lock/unlock button.INPUT SIGNAL AND OUTPUT SIGNAL Signal name Input Output Description Key ID signal Remote keyless entry receiver BCM The BCM receives key ID signal inputs and activates the actuators accordingly...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Checking engine oil level
- GAS STATION INFORMATION
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
