Nissan Murano: Brakes / Brake System :: Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake System :: Removal and Installation

Disc Brake Rotor

Inspection and Adjustment INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist...

Brake Pedal

Exploded View 1. Snap pin 2. Clevis pin 3. Brake pedal assembly 4. Brake pedal pad 5. Clip 6. Stop lamp switch 7. Brake pedal position switch     Removal and Installation REMOVALRemove instrument lower panel LH...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U1505-83 Side Rdr R Can Circ 2


DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition   U1505-83 SIDE RDR R CAN CIR 2 (Side radar right CAN circuit 2) Diagnosis condition When engine is running When Blind Spot Warning system is ON Signal (terminal) ITS communication signal Threshold ADAS control unit detects an error signal that is received from side radar RH via ITS communication Diagnosis delay time 1 second or less POSSIBLE CAUSE Side radar RH ADAS control unit FAIL- SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Confirmation Procedure DTC CONFIRMATION PROCEDURECHECK DTC PRIORITY If DTC “U1505-83” is displayed with DTC “U1000–01” or “U1507-87”, first diagnose the DTC “U1000–01” or “U1507-87”...

Nissan Murano (Z52) 2015-2024 Service Manual: B Terminal Circuit


Diagnosis Procedure CAUTION: Perform diagnosis under the condition that the engine cannot start by the following procedure: Remove fuel pump fuse. Crank or start the engine (where possible) until the fuel pressure is depleted. CHECK TERMINAL B POWER SUPPLY VOLTAGE Ignition switch OFF...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com