Nissan Murano: Brakes / Brake Control System :: Automatic Emergency Braking
Exploded View
1.
Spiral cable
2.
Steering angle sensor
A.
Spiral cable screws
B.
Steering angle sensor screws
C.
Locating pin
Removal and Installation
To remove and install the steering angle sensor, remove and install the spiral cable...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
DTC Description
DTC DETECTION LOGIC
The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking.
The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running...
Park the vehicle on a level surface and
apply the parking brake.
Start the engine and let it idle until it
reaches operating temperature.
Turn off the engine. Wait more than
10 minutes for the oil to drain back
into the oil pan.
Remove the dipstick and wipe it clean...