Nissan Murano: Removal and Installation / Body Construction

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Body Repair :: Repair Information / Removal and Installation / Body Construction

Body Construction

1.	Body side outer	2.	Front pillar inner upper	3.	Upper front pillar reinforcement
4.	Dash side inner	5.	Front hinge pillar lower reinforcement	6.	Outer sill reinforcement
7.	Inner sill	8.	Center pillar reinforcement	9.	Inner center pillar
10.	Rear sill assembly	11.	Rear wheel housing assembly	12.	Back pillar inner reinforcement
13.	Roof rail brace assembly	14.	Back pillar inner	15.	Back pillar seat belt reinforcement

Fusible Insulator Applying Part

NOTE:

Service replacement fusible insulator material is available in varying thickness. Always check with the Parts Department for the latest parts information.

Apply the fusible insulator to prevent road noise, vibration and exhaust system heat inside the vehicle.

The service replacement material is cut-to-fit and not supplied in the same shape as original factory installed fusible insulator.

Place the fusible insulators in the positions shown in the figure and properly affix them to the vehicle surface.

Unit: mm (in)

	: Nissan Murano Vehicle front
	: Fusible insulator thickness 3.5 (0.138)

Unit: mm (in)

	: Nissan Murano Vehicle front
	: Fusible insulator thickness 3.5 (0.138)

Body Sealing

Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps...

Replacement Operations

Precautions for Body Repair WARNING: The repair information in this section is intended for trained body repair technicians who have attained a high level of skill and experience (e...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Driving Force Is Hunting

Diagnosis Procedure The vehicle causes hunting when the ICC system is active.PERFORM SELF DIAGNOSTIC RESULT OF ECM Perform “Self Diagnostic Result” with CONSULT. Check if DTC is detected in “Self Diagnostic Result” of “ENGINE”. Refer to DTC Index...

Nissan Murano (Z52) 2015-2024 Service Manual: C1601 Battery Volt

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1601 BATTERY VOLT (Battery voltage) Diagnosis condition When ignition switch ON. Signal (terminal) Power steering control module supply voltage (terminals 1 and 5) Threshold Less than 8 V or more than 19 V Diagnosis delay time Less than 1 second POSSIBLE CAUSE Harness or connectors Power steering control module Fuse Battery power supply circuit Battery FAIL-SAFEManual steering state DTC Confirmation Procedure PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...