Nissan Murano: Power Supply and Ground Circuit / Air Mix Door Motor Lh
CHECK AIR MIX DOOR MOTOR LH POWER SUPPLY
-
Ignition switch ON.
-
Check voltage between air mix door motor LH harness connector and ground.
+ − Voltage
(Approx.)Air mix door motor LH Connector Terminal M155 1 Ground Battery voltage
Is the inspection result normal?
YES>>GO TO 2.
NO>>GO TO 4.
CHECK AIR MIX DOOR MOTOR LH GROUND CIRCUIT
-
Ignition switch OFF.
-
Disconnect air mix door motor LH connector.
-
Check continuity between air mix door motor LH harness connector and ground.
Air mix door motor LH — Continuity Connector Terminal M155 2 Ground Yes
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair harness or connector.
CHECK INSTALLATION OF AIR MIX DOOR MOTOR LH
Check air mix door motor LH is properly installed. Refer to Exploded View.
Is the inspection result normal?
YES>>Replace air mix door motor LH. Refer to Removal and Installation - (LH).
NO>>Repair or replace malfunctioning part.
CHECK AIR MIX DOOR MOTOR LH POWER SUPPLY CIRCUIT
-
Ignition switch OFF.
-
Disconnect air mix door motor LH connector and A/C auto amp. connector.
-
Check continuity between air mix door motor LH harness connector and A/C auto amp. harness connector.
Air mix door motor LH A/C auto amp. Continuity Connector Terminal Connector Terminal M155 1 M50 17 Yes
Is the inspection result normal?
YES>>Replace A/C auto amp. Refer to Removal and Installation.
NO>>Repair harness or connector.
A/c Auto Amp.
Diagnosis Procedure
CHECK FUSE
Check fuses [No. 14 and 29, located in the fuse block (J/B)].
NOTE:
Refer to Terminal Arrangement.
Is the inspection result normal?
YES>>
GO TO 2...
Air Mix Door Motor Rh
Diagnosis Procedure
CHECK AIR MIX DOOR MOTOR RH POWER SUPPLY
Ignition switch ON.
Check voltage between air mix door motor RH harness connector and ground...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P2119 Electric Throttle Control Actuator
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2119 ETC ACTR-B1 (Throttle actuator control throttle body range/performance) 1 Diagnosis condition — Signal (terminal) — Threshold Electric throttle control actuator does not function properly due to the return spring malfunction Diagnosis delay time — 2 Diagnosis condition — Signal (terminal) — Threshold Throttle valve opening angle in fail-safe mode is not in specified range Diagnosis delay time — 3 Diagnosis condition — Signal (terminal) — Threshold ECM detects that the throttle valve is stuck open Diagnosis delay time — POSSIBLE CAUSE Electric throttle control actuator FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Electric throttle control actuator (When electric throttle control actuator does not function properly due to the return spring malfunction:) ECM controls the electric throttle actuator by regulating the throttle opening around the idle position...
Nissan Murano (Z52) 2015-2024 Service Manual: Luggage Side Lower Finisher
Removal and Installation REMOVALRemove back door kicking plate. Refer to Removal and Installation. Remove rear kicking plate. Refer to Removal and Installation - Rear Kicking Plate. Remove luggage side upper finisher. Refer to Removal and Installation...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- Tire rotation
- Warning lights
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.