Nissan Murano: Power Supply and Ground Circuit / A/c Auto Amp.
CHECK FUSE
Check fuses [No. 14 and 29, located in the fuse block (J/B)].
NOTE:
Refer to Terminal Arrangement.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace the blown fuse after repairing the affected circuit.
CHECK A/C AUTO AMP. POWER SUPPLY
-
Ignition switch OFF.
-
Disconnect A/C auto amp. connector.
-
Check voltage between A/C auto amp. harness connector and ground.
+ − Voltage
(Approx.)A/C auto amp. Ignition switch position Connector Terminal OFF ACC or ON ON or START M50 23 Ground 0 V 0 V Battery voltage 3 Battery voltage Battery voltage Battery voltage
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair harness or connector between A/C auto amp. and fuse block (J/B).
CHECK A/C AUTO AMP. GROUND CIRCUIT
-
Ignition switch OFF.
-
Check continuity between A/C auto amp. harness connector and ground.
A/C auto amp. — Continuity Connector Terminal M50 2 Ground Yes 22
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair harness or connector.
Air Mix Door Motor Lh
Diagnosis Procedure
CHECK AIR MIX DOOR MOTOR LH POWER SUPPLY
Ignition switch ON.
Check voltage between air mix door motor LH harness connector and ground...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Vehicle information display warnings and indicators
Push brake and start switch to drive No Key Detected Shift to Park Key Battery Low Engine start operation for Intelligent Key system (if I-Key battery level is low) Key ID Incorrect Release Parking Brake Low Fuel Low Washer Fluid Door/liftgate Open Key System Fault See Owner’s Manual Loose Fuel Cap Tire Pressure Low – Add Air AWD Error: See Owner’s Manual (if so equipped) AWD High Temp...
Nissan Murano (Z52) 2015-2024 Service Manual: Driver Seat Control Unit
Removal and Installation REMOVALRemove the driver seat. Refer to Removal and Installation. Remove the two driver seat control unit (1) screws (A). : Front Disconnect the two harness connectors from driver seat control unit. Remove driver seat control unit...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Intelligent Forward Collision Warning (I-FCW)
- Indicator lights
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
