Nissan Murano: Basic Inspection / Action Test

Configuration (lane Camera Unit)

Work Procedure Description Since vehicle specifications are not included in the lane camera unit after replacement, it is required to write Nissan Murano vehicle specifications with CONSULT...

Blind Spot Warning

Description Always perform the Blind Spot Warning system action test to check that the system operates normally after replacing the side radar LH/RH, or repairing any Blind Spot Warning system malfunction...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U0104-82 Adas Can 1

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0104-82 ADAS CAN CIR1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Side radar detected an error of ITS communication signal that was received from ADAS control unit Diagnosis delay time – POSSIBLE CAUSE ADAS control unit Side radar LH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...

Nissan Murano (Z52) 2015-2024 Service Manual: System

System Description The system switches fluid pressure of each brake caliper to increase, hold or decrease according to signals from control unit in ABS actuator and electric unit (control unit). This control system is applied to VDC function, TCS function, ABS function, EBD function, brake assist function, hill start assist function and automaticemergency braking function...