Nissan Murano: Road Wheels & Tires :: Removal and Installation / Wheel and Tire
| 1. | Wheel and tire | 2. | Wheel nut |
REMOVAL
Remove wheel nuts using power tool.
Remove wheel and tire.
INSTALLATION
Installation is in reverse order of removal.
CAUTION:
-
When installing wheel nuts, tighten them diagonally by dividing the work two or three times in order to prevent wheels from developing any distortion.
-
Be careful not to tighten wheel nuts to a torque exceeding specification to prevent strain on disc brake rotor.
-
Use Genuine NISSAN wheel nuts.
Tire Pressure Sensor
Exploded View
1.
Tire pressure sensor
2.
Valve cap
3.
Valve core
4.
Valve
A.
Screw
: Parts that are replaced as a set when the tire is replaced...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Power Steering Fluid
Inspection FLUID LEVELVerify proper power steering fluid level. Check power steering fluid level with engine stopped and the fluid temp between 0 – 30° C (32 – 86° F). Power steering fluid level should be within the range shown on the power steering reservoir cap indicator...
Nissan Murano (Z52) 2015-2024 Service Manual: Main Line Between Abs and Hvac Circuit
Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector E152 Harness connector M31 Is the inspection result normal? YES>> GO TO 2...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Rear bench seat adjustment
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
