Nissan Murano: Safety and Health / Working with Body Straightening Equipment
-
Use of work clothes should be the same as for “PROTECTORS”. Refer to Protectors.
-
Wear a safety helmet and safety shoes.
-
When working under a Nissan Murano vehicle or when using a grinder, wear goggles.
-
To prevent danger in case the clamp slips or the panel breaks, be sure to apply a safety chain. Be careful not to stand near the area where the chain is stretched.
-
To prevent danger, any excessive slack in the safety chain must be taken up and properly wound.
-
Do not wear a working glove on the hand that is hammering.
-
Cracked glass must be removed or taped to prevent separation.
-
Any cut panels must be protected with cloth or tape.
-
The seats and glass must be removed or covered with incombustible material, according to the type of work to be done, to prevent contamination and welding spatter.
-
When removing parts, utilize padding (cloth) or protective tape.
Precautions for Operation
Precautions for Operation
In body repair, great importance is attached to quality, efficiency and cost. Consideration for workers' safety and health should, however, be deemed as the most important item...
Working with Grinding the Body Filler (putty)
Danger from Dust
If workers continue to inhale dust generated during paint film removal or body filler grinding work for long periods, they may suffer from respiratory insufficiency, which results in pneumoconiosis or asthma...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: I-Da
System Description SYSTEM DIAGRAMADAS CONTROL UNIT INPUT/OUTPUT SIGNAL ITEMInput Signal Item Transmit unit Signal name Description ABS actuator and electric unit (control unit) CAN communication Nissan Murano Vehicle speed signal Receives the wheel speed of the four wheels Combination meter CAN communication System selection signal Receives a selection state of each item in “Driver Assistance” selected with the combination meter Steering angle sensor CAN communication Steering angle sensor signal Receives the amount of rotation, rotational angle, and rotational direction of the steering wheel Output Signal Item Reception unit Signal name Description Combination meter CAN communication Meter display signal I-DA status signal Transmits a signal and displays the status on the Nissan Murano vehicle information display Sonar control unit ITS communication Buzzer output signal Transmits a buzzer drive signal to activates the warning system buzzer FUNCTION DESCRIPTION The Intelligent Drive Alertness (I-DA) is controlled by the ADAS control unit control unit...
Nissan Murano (Z52) 2015-2024 Owners Manual: BSW system operation
Side BSW/RCTA Indicator Light BSW/RCTA Indicator The BSW system operates above approximately 20 mph (32 km/h). If the radar sensors detect a vehicle in the detection zone, the side BSW/RCTA indicator light (1) illuminates. If the turn signal is then activated, the system chimes (twice) and the side BSW/RCTA indicator light flashes...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- High Beam Assist (if so equipped)
- How to enable/disable the LDW system
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.