Nissan Murano: Service Information / Safety and Health

Mag Welding

MAG Welding MAG welding uses the heat of an electric arc to join two pieces of metal by fusing both the metal and the electrode. For auto repair MAG (Metal Active Gas) are the types of arc welding most often used...

Precautions for Operation

Precautions for Operation In body repair, great importance is attached to quality, efficiency and cost. Consideration for workers' safety and health should, however, be deemed as the most important item...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1a00-44 Control Unit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition   C1A00-44 CONTROL UNIT (Control unit) Diagnosis condition When engine is running Signal (terminal) — Threshold ADAS control unit internal malfunction Diagnosis delay time 1 second or less POSSIBLE CAUSEADAS control unitFAIL-SAFEThe following systems are canceled: Vehicle-to-vehicle distance control mode Conventional (fixed speed) cruise control mode Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Lane Departure Warning (LDW) Intelligent Lane Intervention (I-LI) Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Rear Automatic Braking (RAB) Traffic Sign Recognition (TSR) Intelligent Drive Alertness (I-DA) Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...

Nissan Murano (Z52) 2015-2024 Service Manual: C1602 No Tuning Set

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1602 NO TUNING SET (No tuning set) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold Information in power steering module is not the same Diagnosis delay time — POSSIBLE CAUSE Harness or connector Power steering control module Battery power supply circuit Ignition power supply circuit Battery Fuse Ground circuit FAIL-SAFEManual steering state DTC Confirmation Procedure PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...