Nissan Murano: Driveline :: Rear Final Drive: R145 / Unit Disassembly and Assembly

Unit Removal and Installation. Rear Final Drive Assembly

Exploded View 1. Final drive bracket 2. Stopper 3. Rear final drive assembly Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc...

Electric Controlled Coupling

Exploded View Stud bolt Connector bracket Reamer bolt Electric controlled coupling assembly Wave spring Drive pinion oil seal Drive pinion lock nut Pinion front bearing Gear carrier Collapsible spacer Drive pinion adjusting shim Pinion rear bearing Drive pinion Drive gear Differential case Side bearing Side bearing adjusting shim Side oil seal Rear cover Stud bolt Gasket Drain plug Filler plug Pinion mate thrust washer Pinion mate gear Side gear thrust washer Side gear Pinion mate shaft Lock pin     Oil seal lip Screw hole     : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Always replace after every disassembly...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Rear Usb Charge Port

Removal and Installation REMOVALRemove center console rear finisher. Refer to Exploded View. Using a suitable tool, release pawls and remove rear USB charge port (1) from center console rear finisher (2). : Pawl INSTALLATIONInstallation is in the reverse order of removal...

Nissan Murano (Z52) 2015-2024 Service Manual: P1611 Id Discord, Immu-Ecm

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition P1611 ID DISCORD, IMMU-ECM (Identification discord immobilizer-engine control unit) Diagnosis condition When ignition switch ON...