Nissan Murano: Dtc/circuit Diagnosis / U1a0e Sos Switch on Stuck
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1A0E |
SOS SWITCH ON STUCK (SOS switch ON stuck) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | SOS switch signal | ||
| Threshold | Continue being turned ON | ||
| Diagnosis delay time | 10 seconds or more | ||
POSSIBLE CAUSE
-
Harness or connectors
-
Telematics switch
-
TCU
FAIL-SAFE
-
Telematics system does not function (Only SOS call does not operate)
-
Telematics switch LED indicator is turned OFF
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC U1A0E detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK ECALL SW FOR SHORT CIRCUIT
-
Ignition switch OFF.
-
Disconnect TCU connector and telematics switch connector.
-
Check the continuity between TCU connector and ground.
TCU Ground Continuity Connector Terminal M126 37 — No
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace harness or connectors.
CHECK TELEMATICS SWITCH
Check continuity between telematics switch terminals.
| Telematics switch connector R21 | Condition | Continuity | |
| Terminal | Terminal | ||
| 3 | 7 | Switch pressed | Yes |
| Switch released | No | ||
Is the inspection result normal?
YES>>Replace TCU. Refer to Removal and Installation.
NO>>Replace telematics switch. Refer to Removal and Installation.
U1a0b Mic in Conn
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1A0B
MIC IN CONN
(MIC in conn)
Diagnosis condition
When ignition switch is ON...
U1a10 Airbag Signal
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1A10
AIRBAG SIGNAL
(Airbag signal)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U1a06 Usb Comm
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1A06 TEL ANTENNA ERROR (TEL antenna error) Diagnosis condition When ignition switch is ON. Signal (terminal) TEL antenna signal Threshold No input Diagnosis delay time — POSSIBLE CAUSE TEL antenna signal circuit TEL antenna TCU FAIL-SAFE Telematics switch LED indicator turned OFF (LED indicator turns ON 10 times when SOS call switch is pressed) When telematics system is operated, inform that system cannot be connected to NissanConnect center DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Rear Suspension :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
..
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- High Beam Assist (if so equipped)
- Passenger compartment
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
