DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1304 |
CAMERA IMAGE CALIB (Camera image calibration) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Camera calibration is incomplete.
FAIL-SAFE
Unmatched icon
display (red) is displayed (applicable for unmatched camera only)
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AVM”.
Check DTC.
Is DTC U1304 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM CALIBRATION
When U1304 is detected, perform calibration of camera image.
>>
Refer to Work Procedure.
U1302 Camera Power Volt
Power Supply and Ground Circuit
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.