Nissan Murano: Symptom Diagnosis / The System Does Not Operate Even When Using Turn Signal
CHECK TURN SIGNAL OPERATION
Check that both right and left turn signals are normal.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace malfunctioning parts. Refer to Symptom Table.
PERFORM THE SELF-DIAGNOSIS
CONSULT
-
Perform “All DTC Reading”.
-
Check if any DTC is detected in “Self Diagnosis Result” of “ICC/ADAS”.
Is any DTC detected?
YES>>Repair or replace the malfunctioning parts. Refer to DTC Index.
NO>>Replace the ADAS control unit: Refer to Removal and Installation.
The System Does Not Detect the Vehicle Ahead at All
Diagnosis Procedure
When ICC system is active, the ICC system does not perform any control even through there is a vehicle ahead.CHECK INFORMATION DISPLAY
Start the self-diagnosis mode of combination meter...
The System Operates Even When Using Turn Signal
Diagnosis Procedure
The warning of Lane Departure Warning (LDW) and Intelligent Lane Intervention (I-LI) and the yaw moment control are activated during the use of a turn signal...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Nissan Murano (Z52) 2015-2024 Service Manual: Seat Back Heater Sensor
Component Function Check CHECK SEAT BACK HEATER FUNCTION Check whether or not the temperature of the seat back heater changes in accordance with the HEAT switch operation of the climate controlled seat control switch. Is the inspection result normal? YES>> Inspection End...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- Vehicle Dynamic Control (VDC) OFF switch
- Settings
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
