Nissan Murano: Intelligent Lane Intervention (I-LI) (if so equipped) / System malfunction
If the I-LI system malfunctions, it will cancel
automatically. The LDW indicator (orange)
will illuminate in the display. If the LDWindicator
(orange) illuminates in the display,
pull off the road to a safe location and stop
the vehicle. Turn the engine/motor off and
restart the engine/motor. If the LDWindicator
(orange) continues to illuminate, have
the I-LI system checked. It is recommended
that you visit a NISSAN dealer for
this service.
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in
the direction of the signal...
The lane camera unit for the
I-LI system
is located above the inside mirror. To keep
the proper operation of the I-LI system and
prevent a system malfunction, be sure to
observe the following:
Always keep the windshield clean...
Other information:
Component Parts Location
No. Component Function
1.
Side radar RH
Refer to Side Radar LH/RH.
2.
Lane camera unit
Refer to Lane Camera Unit.
3.
Blind Spot Warning indicator RH
Refer to Blind Spot Warning Indicator LH/RH.
4.
ABS (Anti-lock Braking System) actuator and electric unit (control unit)
ABS actuator and electric unit (control unit) transmits the Nissan Murano vehicle speed signal (wheel speed) and VDC/TCS/ABS system operation condition to ADAS control unit via CAN communication...
Work Flow
OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred.
>>
GO TO 2.
REPRODUCE THE MALFUNCTION
Reproduce the malfunction on the Nissan Murano vehicle that the customer describes...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more