Nissan Murano: Driveline :: Transfer: Ty21c / System Description

Preparation. Preparation

Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-8092) Driver handle Installing drive shaft oil seal (Use with J-52390) — (J-52390) Transfer case seal installer (1) Installing drive shaft oil seal ST33061000 (J-8107-2) Drift Removing ring gear bearing (left) inner race (transfer case side) a: 38 mm (1...

Component Parts. Driveline System

Component Parts Location A. Inside storage room B. Rear final drive No. Component Function 1. Steering angle sensor Mainly transmits the following signal to AWD control unit via CAN communication: Steering angle sensor signal Refer to Component Parts Location for detailed component location...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Engine cooling system

The engine cooling system is filled at the factory with a pre-diluted mixture of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and 50% water to provide year-round antifreeze and coolant protection. The antifreeze solution contains rust and corrosion inhibitors...

Nissan Murano (Z52) 2015-2024 Service Manual: Evap Vapor Lines

Work Procedure CAUTION: Never use compressed air or a high pressure pump. Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improper installation of EVAP service port adapter (commercial service tool) to the EVAP service port may cause a leakage...