Nissan Murano: System Description / System

Shift Lock System

System Description The shift selector lever cannot be shifted from the “P” position unless the brake pedal is depressed while the ignition switch is set to ON...

Cvt Control System

System Description SYSTEM DIAGRAMMAIN CONTROL CONTENTS OF TCM Controls Reference Line pressure control System Description Shift control System Description Select control System Description Lock-up control System Description Fail-safe Fail-safe Self-diagnosis function CONSULT Function Communication function with CONSULT CONSULT Function LIST OF CONTROL ITEMS AND INPUT/OUTPUT Control Item Shift control Line pressure control Select control Lock-up control Fail-safe function* Input Engine torque signal (CAN communication) × × × × × Engine speed signal (CAN communication) × × × × × Accelerator pedal position signal (CAN communication) × × × × Closed throttle position signal (CAN communication) × × × Stop lamp switch signal (CAN communication) × × × × Primary pressure sensor × Secondary pressure sensor × × × CVT fluid temperature sensor × × × × × Primary speed sensor × × × × × Output speed sensor × × × × Input speed sensor × × × × × Transmission range switch × × × × × Manual mode switch (CAN communication) × × × Output Line pressure solenoid valve × × × × Primary pressure solenoid valve × × × Torque converter clutch solenoid valve × × Secondary pressure solenoid valve × × × Select solenoid valve × × × Shift position indicator (CAN communication) × *: If these input/output signals show errors, TCM activates the fail-safe function...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Mood Lamp

Removal and Installation FRONT CONSOLERemovalRemove center console upper side finisher. Refer to Exploded View. Remove mood lamp (front console) (1) screw (B). Release harness connector (A) clip using a suitable tool and disconnect the harness connector from the mood lamp (front console)...

Nissan Murano (Z52) 2015-2024 Service Manual: Brake Pad

Inspection and Adjustment INSPECTIONCheck brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness : Refer to Front Disc Brake. ADJUSTMENTCAUTION: Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage...