Nissan Murano: Luggage Floor Trim / Storage Box
Removal and Installation
REMOVAL
Remove luggage side floor board. Refer to Exploded View.
Raise and support luggage floor board using a suitable tool.
Remove screws (A) and remove storage box side finisher (1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALRemove luggage side upper finisher bolt (A).
Using a suitable tool release pawls and remove second row seat belt d-ring finisher...
Removal and Installation
REMOVALRemove storage box (LH/RH). Refer to Removal and Installation.
Release pawls using a suitable tool and remove back door striker escutcheon...
Other information:
Diagnosis Procedure
Intelligent Key button operation has poor range. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch)
Poor range
OK
OK
OK
DIAGNOSIS PROCEDURERefer to Diagnosis Procedure...
Values on the Diagnosis Tool
CONSULT MONITOR ITEM Monitor Item Condition Value/Status
BSW/CTA WARN STATUS
BSW system is normal
On
BSW system is malfunctioning
Off
CTA SYSTEM ON
CTA system is ON
On
CTA system is OFF
Off
BSW STATUS
BSW system is ON
On
BSW system is OFF
Off
VHCL SPD SE
Indicates current Nissan Murano vehicle speed
km/h
TURN SIGNAL
Left/right turn signal is ON
On
Left/right turn signal is OFF
Off
SHIFT POSITION
Shows the position of the transmission range switch
P/R/N/D
LUMINANCE(LEFT)
Shows radar left luminance level
Hi/Lo
LUMINANCE (RIGHT)
Shows radar right luminance level
Hi/Lo
Reference Value
TERMINAL LAYOUTPHYSICAL VALUES
Terminal No...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more