Nissan Murano: Luggage Floor Trim / Luggage Side Upper Finisher

Luggage Side Lower Finisher

Removal and Installation REMOVALRemove back door kicking plate. Refer to Removal and Installation. Remove rear kicking plate. Refer to Removal and Installation - Rear Kicking Plate...

Storage Box

Removal and Installation REMOVALRemove luggage side floor board. Refer to Exploded View. Raise and support luggage floor board using a suitable tool. Remove screws (A) and remove storage box side finisher (1)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2100 Throttle Control Motor Relay

DTC Description DTC DETECTION LOGIC ECM detects that the voltage of power source for throttle control motor is excessively low. ECM detects that the throttle control motor relay is stuck ON. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2100 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit/open) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects that the voltage of power source for throttle control motor is excessively low Diagnosis delay time — P2103 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit high) Diagnosis condition Ignition switch ON Signal (terminal) Throttle control motor circuit Threshold ECM detects that the throttle control motor relay is stuck ON Diagnosis delay time — POSSIBLE CAUSEDTC P2100 Harness or connectors (Throttle control motor relay circuit is open) Throttle control motor relay DTC P2103 Harness or connectors (Throttle control motor relay circuit is shorted) Throttle control motor relay FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Throttle control motor relay ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx...

Nissan Murano (Z52) 2015-2024 Service Manual: Driver Seat Control Unit

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. CONSULT MONITOR ITEM Monitor Item Condition Value/Status STARTER SW Ignition position Cranking ON Other than above OFF SET SW Set switch Push ON Release OFF MEMORY SW 1 Memory switch 1 Push ON Release OFF MEMORY SW 2 Memory switch 2 Push ON Release OFF DETENT SW CVT selector lever P position OFF Other than above ON STEERING STATUS Power supply position of BCM LOCK LOCK Other than the above UNLOCK SLIDE SW–FR Sliding switch (forward) Operate ON Release OFF SLIDE SW–RR Sliding switch (backward) Operate ON Release OFF RECLN SW–FR Reclining switch (forward) Operate ON Release OFF RECLN SW–RR Reclining switch (backward) Operate ON Release OFF LIFT FR SW–UP Lifting switch front (upward) Operate ON Release OFF LIFT FR SW–DN Lifting switch front (downward) Operate ON Release OFF LIFT RR SW–UP Lifting switch rear (upward) Operate ON Release OFF LIFT RR SW–DN Lifting switch rear (downward) Operate ON Release OFF TILT SW-UP Tilt switch Upward ON Other than above OFF TILT SW-DOWN Tilt switch Downward ON Other than above OFF TELESCO SW-FR Telescopic switch Forward ON Other than above OFF TELESCO SW-RR Telescopic switch Backward ON Other than above OFF MIR CON SW–UP Mirror switch Up ON Other than above OFF MIR CON SW–DN Mirror switch Down ON Other than above OFF MIR CON SW–RH Mirror switch Right ON Other than above OFF MIR CON SW–LH Mirror switch Left ON Other than above OFF MIR CHNG SW–R Select switch Right ON Other than above OFF MIR CHNG SW–L Select switch Left ON Other than above OFF TILT PULSE Tilt position Upward The numeral value decreases * Downward The numeral value increases * Other than above No change to numeral value* TELESCO PULSE Telescopic position Forward The numeral value decreases * Backward The numeral value increases * Other than above No change to numeral value* MIR/SEN RH U–D Door mirror RH Change between 3...