Nissan Murano: Driver Information & Multimedia / Sonar System :: Removal and Installation

Sonar System :: Symptom Diagnosis. Sonar System

Symptom Table Symptom Possible cause Reference page Malfunction is detected in only 1 sensor of display (Always displayed in red). Sonar sensor circuit Sonar sensor DTC Diagnosis Procedure (rear LH inner) DTC Diagnosis Procedure (rear RH inner) DTC Diagnosis Procedure (rear LH outer) DTC Diagnosis Procedure (rear RH outer) DTC Diagnosis Procedure (front LH inner) DTC Diagnosis Procedure (front RH inner) DTC Diagnosis Procedure (front LH outer) DTC Diagnosis Procedure (front RH outer) Removal and Installation Malfunction is detected in all 8 sensors of display (Always displayed in red)...

Sonar Sensor

Removal and Installation REAR SONAR SENSOR OUTERRelease pawls using suitable tool and remove rear sonar sensor (1). NOTE: Rear sonar sensor (inner) shown, rear sonar sensor (outer) similar...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1a04-97 Abs/tcs/vdc Circ

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition   C1A04-97 ABS/TCS/VDC CIRC (ABS/TCS/VDC circuit) Diagnosis condition When engine is running When MAIN switch of ICC system is ON Signal (terminal) — Threshold If a malfunction occurs in the VDC/TCS/ABS system Diagnosis delay time 60 seconds or more POSSIBLE CAUSEABS actuator and electric unit (control unit)FAIL-SAFEThe following systems are canceled: Vehicle-to-vehicle distance control mode Conventional (fixed speed) cruise control mode Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Lane Departure Warning (LDW) Intelligent Lane Intervention (I-LI) Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Rear Automatic Braking (RAB) Confirmation Procedure CHECK DTC PRIORITY If DTC “C1A04–97” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”...

Nissan Murano (Z52) 2015-2024 Service Manual: U1010 Control Unit(can)

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition U1010 CONTROL UNIT(CAN) [Control unit (CAN)] Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold — Diagnosis delay time 2 seconds or more POSSIBLE CAUSEBCMFAIL-SAFE— DTC Diagnosis Procedure Replace BCM When DTC U1010 is detected, replace BCM...