Nissan Murano: Ecu Diagnosis Information / Side Radar Lh
| Monitor Item | Condition | Value/Status |
|---|---|---|
| BSW/CTA WARN STATUS | BSW system is normal | On |
| BSW system is malfunctioning | Off | |
| CTA SYSTEM ON | CTA system is ON | On |
| CTA system is OFF | Off | |
| BSW STATUS | BSW system is ON | On |
| BSW system is OFF | Off | |
| VHCL SPD SE | Indicates current Nissan Murano vehicle speed | km/h |
| TURN SIGNAL | Left/right turn signal is ON | On |
| Left/right turn signal is OFF | Off | |
| SHIFT POSITION | Shows the position of the transmission range switch | P/R/N/D |
| LUMINANCE(LEFT) | Shows radar left luminance level | Hi/Lo |
| LUMINANCE (RIGHT) | Shows radar right luminance level | Hi/Lo |
TERMINAL LAYOUT
PHYSICAL VALUES
|
Terminal No. (Wire color) | Description | Condition |
Value (Approx.) | ||
|---|---|---|---|---|---|
| + | – | Signal name | Input/Output | ||
|
4 (G) |
Ground | Blind Spot Warning indicator | Output |
Approx. 2 sec. after ignition switch OFF ⇒ ON (bulb check) |
12 V |
|
5 (R) |
Ground | Ignition power supply | Input | Ignition switch ON | Battery voltage |
|
6 (L) |
— | ITS communication high | — | — | — |
|
7 (Y) |
— | ITS communication low | — | — | — |
|
8 (B) |
Ground | Ground | — | — | 0 V |
Refer to Fail-safe (Side Radar).
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.
| Priority | Detected items (DTC) |
|---|---|
| 1 |
|
| 2 |
|
| 3 | C1B50-49: SIDE RDR MALFUNCTION |
| 4 |
|
×: Applicable
| DTC | Fail-safe | Reference page | |
|---|---|---|---|
| Blind Spot Warning/Rear Cross Traffic Alert | |||
| C1B50-49 | SIDE RDR MALFUNCTION | × | DTC Description |
| C1B51-16 | BSW/BSI IND SHORT CIR | × | DTC Description |
| C1B52-17 | BSW/BSI IND OPEN CIR | × | DTC Description |
| C1B55-00 | RADAR BLOCKAGE | × | DTC Description |
| U1000-01 | CAN COMM CIRCUIT | × | DTC Description |
| U1010-49 | CONTROL UNIT (CAN) | × | DTC Description |
| U0104-82 | ADAS CAN CIR1 | × | DTC Description |
| U0405-83 | ADAS CAN CIR2 | × | DTC Description |
Front Camera Unit
Values on the Diagnosis Tool
VALUE ON THE DIAGNOSIS TOOLNOTE:
The following table includes information (items) inapplicable to this Nissan Murano vehicle...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: B272d Front Buzzer
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B272D–12 FRONT BUZZER (Sonar buzzer) — Diagnosis condition When ignition switch is ON Signal (terminal) Sonar buzzer power circuit (terminal 19) Sonar buzzer signal (terminal 18) Threshold Sonar buzzer power circuit is short to voltage Sonar buzzer signal circuit is short to voltage Diagnosis delay time — B272D–14 Diagnosis condition When ignition switch is ON Signal (terminal) Sonar buzzer power circuit (terminal 19) Sonar buzzer signal (terminal 18) Threshold Sonar buzzer power circuit is open or short to ground Sonar buzzer signal circuit is open or short to ground Diagnosis delay time — POSSIBLE CAUSE Harness or connectors Sonar buzzer FAIL-SAFE Off indicator blinks periodically (500ms ON, 500ms OFF)...
Nissan Murano (Z52) 2015-2024 Service Manual: Both Side Headlamps (hi) Are Not Turned on
Diagnosis Procedure Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.COMBINATION SWITCH INSPECTION Check combination switch. Refer to Symptom Table. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning part...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- Turning the AEB system on/off
- Rear bench seat adjustment
- New on site
- Most important about car
Unfastening the seat belts. Checking seat belt operation
Unfastening the seat belts
To unfasten the seat belt, press the button
on the buckle 
. The seat belt
automatically
retracts.
Copyright © 2026 www.nimurano.com