Nissan Murano: Service Information / Sheet Metal Work

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Body Repair :: Fundamentals / Service Information / Sheet Metal Work

Sheet Metal Work Tools

Sheet Metal Work Tools This section explains various tools used in body repair work. Hammers A hammer is used to correct dents, projections or other deformations...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance

The sensor for the ICC system is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not attach a sticker (including transparent material) or install an accessory near the sensor...

Nissan Murano (Z52) 2015-2024 Service Manual: Door Mirror Rear Finisher

Removal and Installation REMOVALRemove door mirror glass. Refer to Removal and Installation. Release pawls using a suitable tool and remove door mirror rear finisher. : PawlINSTALLATIONInstallation is in the reverse order of removal.CAUTION: After installation, visually inspect that all pawls are securely engaged...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.