Nissan Murano: Cleaning interior / Seat belts
The seat belts can be cleaned by wiping
them with a sponge dampened in a mild
soap solution. Allow the belts to dry completely
in the shade before using them. For
additional information, refer to “Seat belt
maintenance” in the “Safety—Seats, seat
belts and supplemental restraint system”
section of this manual.
WARNING
Do not allow wet seat belts to roll up in
the retractor. NEVER use bleach, dye or
chemical solvents to clean the seat
belts, since these materials may severely
weaken the seat belt webbing.
WARNING
To avoid potential pedal interference
that may result in a collision, injury or
death:
NEVER place a floor mat on top of another
floor mat in the driver front position
or install them upside down or
backwards...
CAUTION
Periodically clean the seat tracks to prevent
reduction of ability to move the
seats.
Clean periodically with a high-powered
vacuum cleaner...
Other information:
System Description
SYSTEM DIAGRAMSYSTEM DESCRIPTIONThe ECM controls the engine mount operation corresponding to the engine speed. The control system has a 2-step control [Soft/Hard] Vehicle condition Engine mount control
Engine speed: Below 950 rpm
Soft
Engine speed: Above 950 rpm
Hard
ELECTRONIC CONTROLLED ENGINE MOUNT LINE DRAWING
Electronic controlled engine mount control solenoid valve
Intake manifold collector
: From next figure
Front electronic controlled engine mount
Rear electronic controlled engine mount
: To previous figure
NOTE:
Do not use soapy water or any type of solvent while installing vacuum hose...
Description
Always perform the Intelligent Drive Alertness (I-DA) system action test to check that the system operates normally after replacing the around view monitor control unit and any Intelligent Drive Alertness (I-DA) system malfunction.WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test...