Nissan Murano: Cleaning interior / Cleaning the seat tracks
CAUTION
Periodically clean the seat tracks to prevent
reduction of ability to move the
seats.
Clean periodically with a high-powered
vacuum cleaner. Dirt and debris may reduce
the ability to adjust the seat. A wet
cleansing agent may be used if necessary.
The seat belts can be cleaned by wiping
them with a sponge dampened in a mild
soap solution. Allow the belts to dry completely
in the shade before using them...
Most common factors contributing to vehicle corrosion
Most vehicle corrosion is caused by:
The accumulation of moistureretaining
dirt and debris in body panel
sections, cavities, and other areas...
Other information:
Removal and Installation
REMOVALRemove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect the fuel filler lid release cable from the fuel filler lid lock.
Rotate fuel filler lid lock to release pawls and remove.INSTALLATIONInstallation is in the reverse order of removal...
DTC Description
DTC DETECTION LOGIC DTC No.
Trouble diagnosis name
(Trouble diagnosis content) DTC detecting condition Possible cause
P1220
FPCM
(Fuel pump control module)
During engine cranking, the signal voltage of the FPCM to the ECM is too low...
Categories

The gauge indicates the approximate fuel
level in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or
down hills.
The gauge needle returns to 0 (Empty) after
the ignition switch is placed in the OFF
position.
read more