Nissan Murano: Cleaning interior / Floor mats (if so equipped)

WARNING
To avoid potential pedal interference
that may result in a collision, injury or
death:
- NEVER place a floor mat on top of another
floor mat in the driver front position
or install them upside down or
backwards.
- Use only Genuine NISSAN floor mats,
or equivalent floor mats, that are specifically
designed for use in your vehicle
model and model year.
- Properly position the mats in the floorwell
using the floor mat positioning
hook. For additional information, refer
to "Floor mat installation" in this
section.
- Make sure the floor mat does not interfere
with pedal operation.
- Periodically check the floor mats to
make sure they are properly installed.
- After cleaning the vehicle interior,
check the floor mats to make sure
they are properly installed.
The use of Genuine NISSAN floor mats can
extend the life of your vehicle carpet and
make it easier to clean the interior. Mats
should be maintained with regular cleaning
and replaced if they become excessively
worn.
Floor mat installation
Your vehicle is equipped with floor mat positioning
hook(s). The number and shape of the
floor mat positioning hooks for each seating
position varies depending on the vehicle.
When installing Genuine NISSAN floor mats,
follow the installation instructions provided
with the mat and the following:
- With the ignition in the OFF position, the
shift lever in P (Park) position and with
the parking brake fully applied, position
the floor mat in the floorwell so that the
floor mat grommet holes are aligned
with the hook(s).
- Secure the grommet holes into the
hook(s) and ensure that the floor mat is
properly positioned.
- Make sure the floor mat does not interfere
with pedal operation. With the ignition
still in the OFF position, the shift
lever in the P (Park) position and with
the parking brake applied, fully apply
and release all pedals. The floor mat
must not interfere with pedal operation
or prevent the pedal from returning
to its normal position.
It is recommended that you visit a NISSAN
dealer for details about installing the floor
mats in your vehicle.

Positioning hooks
The illustration shows the location of the
floor mat positioning hooks.
The sunshade is made from a tricot material.
CAUTION
To help prevent damaging the moonroof
while cleaning:
Do not rub the material with a cloth.
Doing so can damage the surface of
the material or cause a stain to
spread...
The seat belts can be cleaned by wiping
them with a sponge dampened in a mild
soap solution. Allow the belts to dry completely
in the shade before using them...
Other information:
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Tool number
(TechMate No.)
Tool name Description
—
(J-39570)
Chassis Ear
Locating the noise
—
(J-50397)
NISSAN Squeak and Rattle Kit
Repairing the cause of noise
—
(J-46534)
Trim Tool Set
Removing trim components
Commercial Service Tool
(TechMate No...
Values on the Diagnosis Tool
NOTE:
The following table includes information (items) inapplicable to this Nissan Murano vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items.
Monitor item Condition Value/Status
STOP LAMP SW
Brake pedal: Depressed
On
Brake pedal: Released
Off
ENG SPEED SIG
Engine stopped
(Engine speed: Less than 400 rpm)
Stop
Engine running
(Engine speed: 400 rpm or more)
Run
ETS ACTUATOR
Engine stopped (Ignition switch: ON)
Off
Engine running
On
4WD WARN LAMP
AWD warning icon/display: ON
On
AWD warning icon/display: OFF
Off
4WD MODE SW
Always
AUTO
4WD MODE MON
Always
AUTO
DIS-TIRE MONI
Nissan Murano Vehicle running with normal size tire installed
0 – 4 mm
Nissan Murano Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition)
4 – 8 mm, 8 – mm
P BRAKE SW
Parking brake operated
On
Parking brake not operated
Off
BATTERY VOLT
Always
Battery voltage
THRTL POS SEN
When depressing accelerator pedal
(Value rises gradually in response to throttle position...