Nissan Murano: Basic Inspection / Additional Service When Replacing Can Gateway. 3ch Can Gateway

Description

For work procedure, refer to Work Procedure.

BEFORE REPLACEMENT

When replacing 3CH CAN gateway, save or print current vehicle specification (Type ID) with CONSULT configuration before replacement.

NOTE:

If “Before Replace ECU” of “Read / Write Configuration” can not be used, use the “Manual Configuration” after replacing 3CH CAN gateway.

AFTER REPLACEMENT

CAUTION:

Follow the instructions listed below. Failure to do this may cause malfunctions to the 3CH CAN gateway.:

SAVING VEHICLE SPECIFICATION

CONSULT Configuration

Perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification (Type ID). Refer to Work Procedure (Before Replacement).

NOTE:

If “Before Replace ECU” of “Read / Write Configuration” can not be used, use the “Manual Configuration” after replacing 3CH CAN gateway.

GO TO 2.

REPLACE 3CH CAN GATEWAY

Replace 3CH CAN gateway. Refer to Removal and Installation.

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

Perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” to write Nissan Murano vehicle specification (Type ID). Refer to Work Procedure (After Replacement).

GO TO 4.

CHECK ALL ECU SELF-DIAGNOSIS RESULTS

1. Erase all ECU self-diagnosis results using CONSULT.

2. Turn the ignition switch OFF.

3. Turn the ignition switch ON and wait for 2 seconds or more.

4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.

WORK END