Nissan Murano: Sensor Rotor / Rear Sensor Rotor
The rear wheel sensor rotor is an integral part of the wheel hub and bearing and cannot be disassembled. Refer to Removal and Installation.
Front Sensor Rotor
Removal and Installation - Front Sensor Rotor
The front wheel sensor rotor is an integral part of the wheel hub and bearing and cannot be disassembled...
Abs Actuator and Electric Unit (control Unit)
Exploded View
1.
ABS actuator and electric unit (control unit)
2.
Bracket
A.
To rear (RH) brake caliper. Refer to Exploded View.
B.
From master cylinder secondary side...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: C1761 Temperature Data Fl
DTC Description NOTE: The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTCs Register TPMS sensor IDs DTC DETECTION LOGIC DTC No...
Nissan Murano (Z52) 2015-2024 Service Manual: Rear Window Defogger Relay
Component Function Check CHECK REAR WINDOW DEFOGGER RELAY POWER SUPPLY CIRCUIT Check that an operation noise of rear window defogger relay [located in fuse block (J/B)] can be heard when turning the rear window defogger switch ON. Is the inspection result normal? YES>> Rear window defogger relay power supply circuit is OK...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Warning lights
- Shift lock release
- Power Steering Fluid (PSF)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
