Nissan Murano: Cleaning interior / Power moonroof (if so equipped)

Nissan Murano (Z52) 2015-2024 Owners Manual / Appearance and care / Cleaning interior / Power moonroof (if so equipped)

The sunshade is made from a tricot material.

CAUTION

To help prevent damaging the moonroof while cleaning:

Do not rub the material with a cloth. Doing so can damage the surface of the material or cause a stain to spread.
Never use benzine, thinner or any similar chemical to clean the sunshade. This may discolor the moonroof and damage the surface.
Clean water based stains by patting the surface with a clean soft cloth dampened in warm water. Press a clean dry cloth onto the surface to remove as much dampness as possible and then let air dry.
Clean oil based stains by patting the surface with a clean soft cloth dampened in warm water. Press a clean dry cloth onto the surface to remove as much dampness as possible and then let air dry.

Air fresheners

Most air fresheners use a solvent that could affect the vehicle interior. If you use an air freshener, take the following precautions: Hanging-type air fresheners can cause permanent discoloration when they contact vehicle interior surfaces...

Floor mats (if so equipped)

WARNING To avoid potential pedal interference that may result in a collision, injury or death: NEVER place a floor mat on top of another floor mat in the driver front position or install them upside down or backwards...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2127 App Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the APP sensor 2 is sent to ECM. An excessively high voltage from the APP sensor 2 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2127 APP SEN 2/CIRC (Throttle/Pedal position sensor/switch “E” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from APP sensor 2 to ECM Threshold An excessively low voltage is sent to ECM Diagnosis delay time — P2128 APP SEN 2/CIRC (Throttle/Pedal position sensor/switch “E” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from APP sensor 2 to ECM Threshold An excessively high voltage is sent to ECM Diagnosis delay time — POSSIBLE CAUSEDTC P2127 Harness or connectors (APP sensor 2 circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Owners Manual: RAB system limitations

WARNING Listed below are the system limitations for the RAB system. Failure to follow the warnings and instructions for proper use of the RAB system could result in serious injury or death. When the vehicle approaches an obstacle while the accelerator or brake pedal is depressed, the function may not operate or the start of operation may be delayed...