Nissan Murano: Rear Door Lock / Inside Handle

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Removal and Installation / Rear Door Lock / Inside Handle

Removal and Installation

REMOVAL

Remove rear door finisher. Refer to Removal and Installation.

Remove inside handle screws.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • After installation, check door lock cables are properly engaged to inside handle.

  • After installation, check door open/close and lock/unlock operation.

    Door Lock

    Exploded View 1. Outside handle escutcheon 2. Rear gasket 3. Outside handle bracket 4. Outside handle 5. Front gasket 6. Inside door handle 7...

    Outside Handle

    Removal and Installation REMOVALFully close rear door glass. Remove rear door finisher. Refer to Removal and Installation. Remove rear door vapor barrier...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: B2409 Half Latch Sw


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2409–71 HALF LATCH SW (Half latch switch) Diagnosis condition All times Signal (terminal) Half latch switch signal (automatic back door control module connector terminal: 7) Threshold When all of the following conditions are satisfied Back door: half latch or open Half latch switch: ON → OFF Diagnosis delay time – POSSIBLE CAUSE Entry of foreign materials to back door lock assembly Back door mechanism Half latch switch Harness or connectors (half latch switch circuit is open or shorted) Automatic back door control module FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

    Nissan Murano (Z52) 2015-2024 Service Manual: C1a15-64 Gear Position


    DTC Description ADAS control unit judges the gear position based on the following signals. Current gear position signal transmitted from TCM via CAN communication. Value of gear ratio calculated from input speed signal transmitted from TCM via CAN communication...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com