Nissan Murano: Removal and Installation / Rear Combination Lamp (back Door Side)

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Exterior Lighting System :: Led Headlamp / Removal and Installation / Rear Combination Lamp (back Door Side)

Exploded View

1. Rear combination lamp (back door side) A. Harness connector Metal stud
Clip
Removal and Installation

REMOVAL

Remove back door lower finisher. Refer to Removal and Installation.

Remove rear combination lamp (back door side) nuts.

Disconnect harness connector, pull rear combination lamp (back door side) rearward and remove.

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

TAIL LAMP BULB

The tail lamp bulb is LED and not serviced separately. Refer to Removal and Installation.

BACK-UP LAMP BULB

The-back up lamp bulb is LED and not serviced separately. Refer to Removal and Installation.

    License Plate Lamp

    Exploded View 1. License plate lamp 2. Back door outer finisher Clip Pawl     Removal and Installation REMOVALRemove back door outer finisher...

    Rear Reflex Reflector

    Exploded View 1. Rear reflex reflector Clip Removal and Installation REMOVALRemove rear bumper fascia. Refer to Removal and Installation. Remove rear reflex reflector fixing screw and pawls and then remove rear reflex reflector...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: B2e33 Ecall Button


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E33 ECALL BUTTON (Ecall button) Diagnosis condition When ignition switch is ON. Signal (terminal) SOS switch LED signal (terminal 5) Threshold — Diagnosis delay time 1 second or more POSSIBLE CAUSE SOS switch LED signal circuit SOS switch TCU FAIL-SAFE Telematics system does not function (Only SOS call does not operate) SOS switch LED indicator is turned OFF DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

    Nissan Murano (Z52) 2015-2024 Service Manual: Seat Belt Retractor


    Removal and Installation SEAT BELT RETRACTOR - (LH/RH)RemovalWARNING: Before servicing the SRS, turn the ignition switch OFF, disconnect both battery terminals then wait at least three minutes. Do not drop the seat belt retractor. Always handle it with care...

    Categories

    Unfastening the seat belts. Checking seat belt operation

    Unfastening the seat belts

    Nissan Murano. Unfastening the seat belts. Checking seat belt operation

    To unfasten the seat belt, press the button on the buckle Nissan Murano. Unfastening the seat belts. Checking seat belt operation. The seat belt automatically retracts.

    read more

     
    Copyright © 2026 www.nimurano.com