Nissan Murano: Front Disc Brake / Brake Pad

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake System :: Periodic Maintenance / Front Disc Brake / Brake Pad

Inspection and Adjustment

INSPECTION

Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary.

Wear thickness

: Refer to Front Disc Brake.

ADJUSTMENT

CAUTION:

Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage.

Be careful of Nissan Murano vehicle speed. Brakes do not operate firmly/securely until pads and disc rotor are securely seated.

Only perform this procedure under safe road and traffic conditions. Use extreme caution.

Drive the vehicle on straight, flat road.

Depress the brake pedal until the vehicle stops.

Release the brake pedal for a few minutes to allow the brake components to cool.

Repeat steps 1 to 3 until pad and disc rotor are securely seated.

Front Disc Brake

Disc Brake Rotor

Inspection and Adjustment INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Working with Body Straightening Equipment

Use of Protectors Use of work clothes should be the same as for “PROTECTORS”. Refer to Protectors. Wear a safety helmet and safety shoes. When working under a Nissan Murano vehicle or when using a grinder, wear goggles. Precautions while Working To prevent danger in case the clamp slips or the panel breaks, be sure to apply a safety chain...

Nissan Murano (Z52) 2015-2024 Service Manual: Brake Pedal

Adjustment BRAKE PEDAL HEIGHTRemove instrument lower panel LH. Refer to Removal and Installation. Disconnect the harness connectors from the stop lamp switch and brake pedal position switch. Turn the stop lamp switch and brake pedal position switch 45° counterclockwise...