Nissan Murano: Audio, Visual & Navigation System :: Telematics System / Preparation. Preparation

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Telematics System / Preparation. Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.
Tool number (TechMate No.) Tool name		Description
— (J-46534) Trim Tool Set		Removing trim components
— (J-51922) Enhanced Multi-Media Interface Tester (EMMIT)		Tests the functionality of the following features: Bluetooth Pairing/Connecting Phonebook Access Profile Hands Free Profile (for calls) Bluetooth Audio test Message Access Profile (for text messages, if equipped) USB Tests USB music playback Tests USB music browsing capability AUX Tests AUX Jack playback

Commercial Service Tool

Tool name		Description
Power tool		Loosening nuts, screws and bolts

Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

System Description

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Washer Fluid Level Switch Circuit

Diagnosis Procedure CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT Ignition switch OFF. Disconnect combination meter harness connector and washer fluid level switch harness connector. Check continuity between combination meter harness connector and washer fluid level switch harness connector...

Nissan Murano (Z52) 2015-2024 Service Manual: Periodic Maintenance. Rear Propeller Shaft

Inspection LOOSENESS OF CONNECTED PARTCheck each fixing bolt and nut for looseness using torque wrench. For each tightening torque, refer to Exploded View.BACKLASH OF JOINT PARTMove the joint of propeller shaft up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the joint has no backlash...