Nissan Murano: Electrical & Power Control / Power Supply, Ground & Circuit Elements :: Removal and Installation

Fusible Link Inspection

Fusible Link A melted fusible link can be detected either by visual inspection or by feeling with a finger tip. If its condition is questionable, use circuit tester or test lamp...

Battery Terminal with Fusible Link

Exploded View 1. Cover 2. Positive terminal 3. Battery 4. Harness connectors 5. Fusible link box (battery) 6. Positive cable Front Removal and Installation REMOVALDisconnect negative battery terminal...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P1225 Tp Sensor

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1225 CTP LEARNING-B1 (Closed throttle position learning performance) Diagnosis condition Ignition switch ON Signal (terminal) Electric throttle control actuator signal Threshold Closed throttle position learning value is excessively low Diagnosis delay time — POSSIBLE CAUSE Electric throttle control actuator (TP sensor 1 and 2) FAIL-SAFENot applicable DTC Confirmation Procedure PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...

Nissan Murano (Z52) 2015-2024 Service Manual: Vdc Off Indicator Lamp

Component Function Check CHECK VDC OFF INDICATOR LAMP FUNCTION (1) Check that VDC OFF indicator lamp in combination meter turns ON for 1 second after ignition switch ON. CAUTION: Never start the engine. Is the inspection result normal? YES>> GO TO 2...