Nissan Murano: Basic Inspection / Clutch Point Learning

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f10j / Basic Inspection / Clutch Point Learning

Description

TCM memorizes a clutch point (engagement timing), and this enables accurate control. For work procedure, refer to Work Procedure.

Work Procedure

CLUTCH POINT LEARNING

With CONSULT

Start the engine.
Select “Work Support” in “TRANSMISSION”.
Select “FWD CLUTCH POINT LEARNING”.
Perform learning according to the CONSULT display.

CAUTION:
After the completion in D position, perform in R position.

WORK END

Additional Service When Replacing Tcm and Transaxle Assembly

Description When replacing TCM and transaxle assembly simultaneously, perform the following work. For work procedure, refer to Work Procedure.NOTE: The CD provided with the new transaxle assembly contains important calibration data that must be installed with CONSULT after installation of the new transaxle assembly...

Select Learning

Work Procedure NOTE: If Clutch Point Learning is also required, always perform Clutch Point Learning before Select Learning. Perform Select Learning with CVT fluid temperature below 50°C (122°F) and again with fluid temperature above 50°C (122°F)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Dlc Branch Line Circuit

Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). Data link connector 3CH CAN gateway Is the inspection result normal? YES>> GO TO 2...

Nissan Murano (Z52) 2015-2024 Service Manual: Intelligent Key

CONSULT Function (BCM - INTELLIGENT KEY) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Main Description REQ SW -DR [On/Off] × Indicates condition of door request switch LH...