Nissan Murano: Vehicle security system / How to stop an activated alarm
The alarm stops only by unlocking the driver’s
door or the liftgate with the key (if so
equipped), pressing the
button on
the Intelligent Key, or pushing the request
switch on the driver’s or passenger’s door
with the Intelligent Key in range of the door
handle.
The vehicle security system will give the
following alarm:
The turn signals blink and the horn
sounds intermittently.
The alarm automatically turns off after
a period of time...
The NISSAN Vehicle Immobilizer System
will not allow the engine to start without
the use of a registered key.
Never leave these keys in the vehicle.
FCC Notice:
For USA:
This device complies with Part 15 of the
FCC Rules...
Other information:
DTC Description
BCM performs ID verification between BCM and dongle unit.When verification result is OK, BCM permits cranking.DTC DETECTION LOGICNOTE:
If DTC B2196 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Description...
DTC Description
DTC DETECTION LOGICMalfunction related to AWD solenoid has been detected. DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detecting condition
C1204
4WD SOLENOID
(4WD solenoid)
Diagnosis condition
Ignition switch: ON
Signal
—
Threshold
—
Diagnosis delay time
—
POSSIBLE CAUSE
Internal malfunction of electronic controlled coupling
Malfunction of AWD solenoid power supply circuit (open or short)
Malfunction of AWD solenoid command current
FAIL-SAFEFront-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque)...