Nissan Murano: Instruments and controls / Heated steering wheel switch (if so equipped)
The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below 68°F (20°C).
Push the heated steering wheel switch to warm the steering wheel after the ignition switch is placed in the ON position. The indicator light will come on.
If the surface temperature of the steering wheel is below 68°F (20°C), the system will heat the steering wheel and cycle off and on to maintain a temperature above 68°F (20°C). The indicator light will remain on as long as the system is on.
Push the switch again to turn the heated steering wheel system off manually. The indicator light will go off.
NOTE:
Once activated, your heated steering wheel will automatically turn on and off to maintain a temperature above 68°F (20°C).
Whenthe temperature of the steering wheel is above 122°F (50°C) and the heated steering wheel switch is turned on, the system will not heat the steering wheel. This does not indicate a malfunction.
Heated rear seat switches (if so equipped)
WARNING
Do not use or allow occupants to use
the seat heater if you or the occupants
cannot monitor elevated seat temperatures
or have an inability to feel pain in
body parts that contact the seat...
Dynamic driver assistance switch (if so equipped)
The dynamic driver assistance switch is
used to temporarily activate the Intelligent
Lane Intervention (I-LI) system that is enabled
using the settings menu of the vehicle
information display...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Memory Storing
Description Always perform the memory storage when the battery terminal is disconnected or the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed. Work Procedure Memory Storage ProcedureTwo positions for the driver seat, steering column and outside mirror can be stored for memory operation by the following procedure:STEP 1 Check the following conditions: Ignition switch: ON CVT shift selector: P (Park) position >> GO TO 2...
Nissan Murano (Z52) 2015-2024 Service Manual: Power Supply and Ground Circuit. Ipdm E/r (intelligent Power Distribution Module Engine Room)
Diagnosis Procedure CHECK FUSIBLE LINKS Check that the following fusible links are not blown: Terminal Signal name Fusible link No. Capacity 1 Battery power supply E 80 A 2 A 250 A C 80 A 3 A 250 A B 100 A N 40 A Is the fusible link blown? YES>> Replace the blown fusible link after repairing the affected circuit...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- Jacking up vehicle and removing the damaged tire
- High Beam Assist (if so equipped)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
