Nissan Murano: Removal and Installation / Gps Antenna
Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to Removal and Installation.
Remove screw to remove GPS antenna from instrument panel.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALLower headlining (rear). Refer to Exploded View.
Disconnect the harness connectors from the antenna feeder.
Loosen bolt (A) and remove roof antenna (1)...
Removal and Installation
REMOVALRemove front room\map lamp assembly. Refer to Removal and Installation.
Disconnect the harness connector (A) from front room\map lamp assembly (2)...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U111A
REAR CAMERA IMAGE SIGNAL
(CAN COMM CIRCUIT)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear camera image signal (terminal 20)
Threshold
Rear camera image signal circuit is shorted or open
Diagnosis delay time
—
POSSIBLE CAUSE
Rear camera image signal circuit
Around view monitor control unit
Rear camera
FAIL-SAFECamera image is not displayed (gray screen display)
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Removal and Installation
REMOVALSupport back door using a suitable tool.
WARNING:
Bodily injury may occur if back door is not supported properly when removing back door spindle unit.
Remove luggage side upper finisher. Refer to Removal and Installation...