Nissan Murano: Suspension / Front Suspension :: Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Suspension / Front Suspension :: Removal and Installation

Wheel Alignment

Inspection PRELIMINARY INSPECTIONWARNING: Always adjust wheel alignment with vehicle on a flat surface. NOTE: If wheel alignment is out of specification, inspect and replace any damaged or worn suspension parts before making any adjustments...

Front Coil Spring and Strut

Exploded View 1. Piston rod lock nut 2. Strut mount insulator 3. Strut mount bearing 4. Front coil spring 5. Bound bumper 6. Lower rubber seat 7...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Outer Finisher


Exploded View 1. Back door outer finisher 2. Rear view camera 3. Back door request switch Clip Removal and Installation REMOVALRemove back door lower finisher. Refer to Removal and Installation. Disconnect the harness connectors from back door request switch and rear view camera...

Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Weather-Strip


Removal and Installation REMOVALCarefully remove back door weather-strip from opening door joint.INSTALLATIONNOTE: Pull weather-strip gently to ensure that there are no loose sections. Beginning with upper section, align weather-strip mark with vehicle center position mark and install weather-strip to Nissan Murano vehicle...

Categories

Luggage hooks

Nissan Murano. Luggage hooks

When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

read more

 
Copyright © 2026 www.nimurano.com