Nissan Murano: Mirrors :: Removal and Installation / Door Mirror Rear Finisher

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Mirrors :: Removal and Installation / Door Mirror Rear Finisher

Removal and Installation

REMOVAL

Remove door mirror glass. Refer to Removal and Installation.

Release pawls using a suitable tool and remove door mirror rear finisher.

: Pawl

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

After installation, visually inspect that all pawls are securely engaged.

Door Mirror Glass

Removal and Installation REMOVALApply protective tape to door mirror. Release metal clips and pawls that retain door mirror glass using a suitable tool, disconnect harness connectors (A)(if equipped) from door mirror glass and remove...

Door Mirror Actuator

Removal and Installation REMOVALRemove door mirror glass. Refer to Removal and Installation. Remove screw (A) from door mirror actuator (1). Disconnect harness connector from door mirror actuator and remove...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Clutch Point Learning

Description TCM memorizes a clutch point (engagement timing), and this enables accurate control. For work procedure, refer to Work Procedure. Work Procedure CLUTCH POINT LEARNING With CONSULT Start the engine. Select “Work Support” in “TRANSMISSION”...

Nissan Murano (Z52) 2015-2024 Service Manual: C1735 Ign Circuit Open

DTC Description NOTE: The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTCs Register TPMS sensor IDs DTC DETECTION LOGIC DTC No...